Criteria

Text:
Topic:
Content:
Display:

Results

Viewing 1 to 30 of 125
2014-06-05
Standard
J499_201406
This Information Report along with SAE J500 and J501 is generally understood to be technically obsolete for the design of new applications. However, it is listed for those existing applications where it may be required. For the design of new applications, consult ANSI B92.1-1970—Involute Splines and Inspections Standard. [The dimensions, given in inches, apply only to soft broached holes. The shaft dimensions depend upon the shape and material of the parts, their heat treatment, and methods of machining to give the required fit. The method and amount of "breaking" sharp corners and edges also depend upon the conditions and requirements of each application. The formula for theoretical torque capacity (pressure on sides of spline) in inch-pounds per inch of bearing length (L) and at 1000 psi pressure is: The tolerances allowed are for good construction and may be readily maintained by usual broaching methods.
2014-06-05
Standard
J501_201406
2002-12-16
Standard
AS474
ABSTRACT
2002-12-16
Standard
AS521
ABSTRACT
2002-12-16
Standard
AS535
ABSTRACT
2002-12-16
Standard
ARP466
ABSTRACT
2002-12-16
Standard
AS481
ABSTRACT
2001-10-01
Standard
AS527A
2001-10-01
Standard
AS526A
2001-01-01
Standard
AS468C
2001-01-01
Standard
AS470C
2001-01-01
Standard
AS472C
2001-01-01
Standard
AS471C
Viewing 1 to 30 of 125

Filter

  • Standard
    125