Criteria

Text:
Sector:
Content:
Display:

Results

Viewing 1 to 30 of 13411
CURRENT
2017-12-14
Standard
AS21442B
SCOPE IS UNAVAILABLE.
2017-12-13
WIP Standard
AS6075A
Scope unavailable.
2017-12-13
WIP Standard
AS6105A
Scope unavailable.
2017-12-13
WIP Standard
AS6213A
Scope is unavailable.
2017-12-13
WIP Standard
AS6099A
Scope unavailable.
2017-12-13
WIP Standard
AS6103A
Scope unavailable.
2017-12-13
WIP Standard
AS6104A
Scope is unavailable.
2017-12-12
WIP Standard
MA3354D
Scope is unavailable.
CURRENT
2017-12-12
Standard
AS6369/2
This is the sheet metal flange design standard for the new AS6369 specification.
CURRENT
2017-12-12
Standard
AS6369
This SAE Aerospace Standard (AS) establishes the requirements for a grooved clamp coupling and flanges suitable for joining intermediate pressure and temperature ducting in aircraft pneumatic systems. The coupling joint assembly, hereafter referred to as "the joint", shall operate within the temperature range of -65 °F external ambient to +800 °F internal fluid.
CURRENT
2017-12-12
Standard
AS4716C
This SAE Aerospace Standard (AS) provides standardized gland (groove) design criteria and dimensions for O-ring seal glands for static and dynamic applications, and other seals.
CURRENT
2017-12-12
Standard
AS6369/1
SCOPE IS UNAVAILABLE.
CURRENT
2017-12-12
Standard
AS6369/3
This is the solid flange design standard for the new AS6369 specification.
2017-12-08
WIP Standard
AS85421B
Revision clarifies qualification/manufacturing details regarding initial form of fitting (standard near-net forgings, oversize forgings or bar stock). Additionally, replacing the lot-to-lot destructive testing with standardized periodic test procedures.
CURRENT
2017-12-07
Standard
AS1650E
This SAE Aerospace Standard (AS) defines the requirements for a threadless, flexible, self-bonding coupling assembly which, when installed on machined fixed cavity ferrules, provides a flexible connection for joining tubing and components in aircraft fuel, vent or other systems. This assembled coupling, hereafter referred to as the assembly, and is designed for use from -65 to +400 °F and at 125 psig nominal operating pressure. AS1650 was not designed for the new certification requirements for flammable leakage zones and fuel tanks for lightning protection and assembly redundancy. As such their use and installation may require additional efforts and equipment to support new FAA CFR compliance. The AS7510 flexible coupling should be the preferred coupling for use in flammable leakage zones and fuel tanks that require service life and functionality for lightning protection and part redundancy.
2017-12-07
WIP Standard
AS848A
No scope available.
2017-12-07
WIP Standard
AS7232A
This procurement specification covers aircraft quality solid rivets and tubular end rivets made form a corrosion and heat resistant nickel base alloy of the type identified under the Unified Numbering System as UNS N06600. Primarily for fastener applications requiring corrosion resistance and heat and oxidation resistance up to 2000 degrees F, but with reduced strength at the elevated temperatures. Rivets shall not be hand peened during driving.
Viewing 1 to 30 of 13411

Filter

  • Aerospace
    13411
  • Standard
    13411

Subtopics